Roofers for Pretoria and Centurion homes, estates & complexes

IBR & corrugated | Pretoria

IBR and Corrugated Roof Repairs in Pretoria

IBR roof repairs in Pretoria, along with corrugated sheeting: loose screws, failed washers, rusted sheets, open laps, lifted sheets and flashings.

Metal roofs rarely fail all at once. They fail at the fixings and overlaps, one small gap at a time.

IBR, Corrugated and Coated Steel Sheeting

IBR (with its trapezoidal ribs) and corrugated (with its rounded waves) are the two sheet profiles we see most often across Pretoria, on whole houses, on extensions, carports, patios and outbuildings, and on commercial and industrial buildings. Sheets may be bare galvanised steel or pre-painted coated steel. Both profiles work well at low roof pitches, which is why they are used where tiles cannot be.

Screws, Washers and Sheet Laps

Each sheet is held down by screws through the crests of the profile, sealed with a rubber or neoprene washer. In strong sun those washers harden and crack, and water runs down the screw shaft into the roof. Screws can also rust, or work loose as the steel expands in the heat of the day and contracts at night.

Where two sheets overlap, the lap must face away from the prevailing wind and run in the right direction down the slope. Laps that were installed the wrong way round, or that have opened up as fixings loosened, let storm rain in sideways. We replace perished fixings with new screws and washers of the correct type and length, and close up laps that have opened.

Rust, Lifted Sheets and Wind Damage

Rust usually starts where water sits: at laps, around fixings, at the bottom of the sheet where it meets the gutter, and where leaves collect. Surface rust can be treated, but once it has eaten through, the sheet should be replaced. Patching a rusted-through sheet only moves the leak a few centimetres along.

Highveld storms bring strong gusts. Sheets with too few fixings, or fixed into rotten purlins, can lift at the edges and eventually tear free. We refix lifted sheets into sound timber or steel, replace damaged sheets, and check the edges and barge flashings that resist wind uplift.

Flashings and Penetrations

Ridge cappings, apron flashings where a lean-to meets a wall, side flashings and barge cappings all need to be fixed and lapped correctly. So does every pipe or bracket that passes through the roof: geyser vents, extractor ducts, solar mounting rails and aerial brackets. These are some of the most common leak points on a sheeted roof, and they are repaired with correctly shaped flashings rather than a blob of sealant.

When Sheeting Should Be Replaced Rather Than Patched

If rust has broken through on most sheets, or a roof has been patched so often that new leaks keep appearing, replacing the sheeting is usually better value than another round of repairs. We can quote for replacing the worst sheets only, or for re-roofing the whole area, so that you can compare.

For tile roofs on the same property, see tiled roof repairs; for help tracing a leak, see roof leak repairs. We work on sheeted roofs across Pretoria, including the many carports, patios and outbuildings in Montana and Pretoria North.

Your written quote

What a Sheeted-Roof Quote Includes

  • Fixings to replace, type and quantity
  • Laps to close or re-seal
  • Sheets to replace, with profile and finish
  • Flashings and cappings to replace or re-fix
  • Purlin or batten problems found
  • Price in rand and expected time on site

Carports, Patios and Outbuildings

Many Pretoria homes with tiled main roofs still have IBR or corrugated sheeting over carports, patios, garages and outbuildings. These smaller roofs are easy to forget until they leak onto a car or a stoep. The same faults apply: failed screws, rusted laps and loose flashings where the sheeting meets a wall. We are happy to look at these on their own or along with work on the main roof.

IBR and corrugated roof repairs

Request an IBR Roof Quote

Send photos of the roof, any rust or lifted sheets, and your suburb.

Request an IBR roof quote →